Printed nylon soft outer shell in ocean prints. Fully lined with mesh. Cotton terry crotch liner to provide softness and a tiny bit of absorbency. Adjustable waist with ties. A swim diaper for use in private or public pools.

You should use a swim diaper only while in the pool. It is not made to take the place of a regular cloth diaper or cloth diaper cover (you can put a prefold on there on the way to the pool, the swim diaper can act as a diaper cover for a short amount of time). Machine wash and dry.

Note: This is not a diaper in the sense that we use the word diaper on the rest of the website. Kushies uses the word diaper in the product name to be consistent with the disposable types. It does not however act like what we think of as a diaper - that is cloth in some form that absorbs.

All swim diapers (disposable included) are made to keep poop in the diaper and out of the pool. Even the disposables don't absorb pee. If you think about it, they couldn't absorb anything or when you got in the pool they would just absorb the pool water until the diaper was full.

Available in Blue or Purple/Pink Print. Trim color may vary.

Bummis original wrap is made out of 100% nylon with a polyurethane waterproof coating. An interior mesh lining made of polyester helps keep the diaper in place. The leg and waist binding is very soft lycra. This is a great cover for hot weather because it is very lightweight. The medium size and up have a 3" wide panel of velcro that is very durable. These covers are best used during the day. The mesh liner can cause the cover to wick moisture where the velcro is sewn down if the diaper gets too wet. Use with prefold diapers, this cover doesn't fit well over fitted diapers. The newborn size is made for small babies, like preemies and multiples with a narrow band of velcro. The small size is made to fit an average sized newborn with a soft band of fabric at the top front of the diaper that helps the cord heal. On the larger sizes, the velcro tabs are harder for your little one to get off. Machine or hand wash, hang to dry. White only.

These covers also make nice swim diapers.

Diaper Cover Quick Guide

When trying to decide upon a cover size, start with the suggested weights and then see if the waist, leg and rise measurements of your baby fall into the range of that cover. If you start with the measurements you may end up with a cover that is way too big. For all the velcro covers, you are looking for waist and leg measurements that fall in about the same place in the range. The smallest leg measurements were taken when the cover was fastened on the smallest waist setting. If your baby’s waist measurement is on the lower end of the range and the leg measurement is on the higher end of the range, the cover will probably be too tight at the legs. Made in Canada by Bummis.

Each Bummis cover is sized differently. Please check measurements before you order.

Extra soft polyurethane laminate outer. Soft nylon/lycra elastic at the waist and legs. Flap sewn on the inside covers the stitching where the velcro is sewn to prevent leaks.

This cover has the softest hand of any cover that I have seen. Extra wide velcro gets proportionally bigger with each size so you get a really adjustable fit in the larger sizes. The newborn and small sizes run a little big, so don't size up if you think that your baby should fit in that size.

Wash warm, hang or low dry. Made in Sweden.

For all the velcro covers, you are looking for waist and leg measurements that fall in about the same place in the range. The smallest leg measurements were taken when the cover was fastened on the smallest waist setting. If your baby’s waist measurement is on the lower end of the range and the leg measurement is on the higher end of the range, the cover will probably be too tight at the legs.

Diaper Cover Quick Guide