Bummis original wrap is made out of 100% nylon with a polyurethane
waterproof coating. An interior mesh lining made of polyester helps keep the
diaper in place. The leg and waist binding is very soft lycra. This is a
great cover for hot weather because it is very lightweight. The medium size
and up have a 3" wide panel of velcro that is very durable. These
covers are best used during the day. The mesh liner can cause the cover to
wick moisture where the velcro is sewn down if the diaper gets too wet. Use
with prefold diapers, this cover doesn't fit
well over fitted diapers. The newborn size is made for small babies, like preemies
and multiples with a
narrow band of velcro. The small size is made to fit an average sized
newborn with a soft band of fabric at the top front of the diaper that helps
the cord heal. On the larger sizes, the velcro tabs are harder for your
little one to get off. Machine or hand wash, hang to dry. White only.
When trying to decide upon a cover size, start
with the suggested weights and then see if the waist, leg and rise measurements
of your baby fall into the range of that cover. If you start with the
measurements you may end up with a cover that is way too big. For all the velcro covers, you are looking for waist
and leg measurements that fall in about the same place in the range. The
smallest leg measurements were taken when the cover was fastened on the
smallest waist setting. If your baby’s waist measurement is on the lower
end of the range and the leg measurement is on the higher end of the range,
the cover will probably be too tight at the legs. Made in Canada by Bummis.
Bummis Original
Waist
Leg
Rise
Newborn 4-8 lbs.
9-12"
4-6"
12"
Small 7-13 lbs.
11-16"
5-8"
14"
Medium 13-20 lbs.
13-19"
7-10"
16"
Large 20-28 lbs.
14-21"
8-12"
17.5"
XLarge 28-35 lbs.
15-23"
9-13"
18.5"
XXLarge 35-42 lbs.
16-25"
9-14"
19"
Each Bummis cover is sized differently. Please check measurements before you order.
If you have any
questions about the products on our web site or questions about cloth diapering
in general please use our FAQs or the 'Contact Us' link in the Help section.
